Allow both strings to be omitted in "${if" expansions: the true value

[exim.git] / doc / doc-txt / NewStuff

diff --git a/doc/doc-txt/NewStuff b/doc/doc-txt/NewStuff
index 19150e85f555f67c79942418b1b91941003aeb7e..d5d3407139a2e7a3ec61d353b702b1aabf91c6ea 100644 (file)
--- a/doc/doc-txt/NewStuff
+++ b/doc/doc-txt/NewStuff
@@ -1,4 +1,4 @@
-$Cambridge: exim/doc/doc-txt/NewStuff,v 1.8 2004/11/10 10:29:56 ph10 Exp $
+$Cambridge: exim/doc/doc-txt/NewStuff,v 1.11 2004/11/17 16:12:26 ph10 Exp $
 
 New Features in Exim
 --------------------
@@ -67,6 +67,46 @@ Version 4.44
     monitoring the behaviour of the daemon without creating as much output as
     full debugging.
 
+ 9. $host_address is now set to the target address during the checking of
+    ignore_target_hosts.
+
+10. There are four new variables called $spool_space, $log_space,
+    $spool_inodes, and $log_inodes. The first two contain the amount of free
+    space in the disk partitions where Exim has its spool directory and log
+    directory, respectively. (When these are in the same partition, the values
+    will, of course, be the same.) The second two variables contain the numbers
+    of free inodes in the respective partitions.
+
+    NOTE: Because disks can nowadays be very large, the values in the space
+    variables are in kilobytes rather than in bytes. Thus, for example, to
+    check in an ACL that there is at least 50M free on the spool, you would
+    write:
+
+       condition = ${if > {$spool_space}{50000}{yes}{no}}
+
+    The values are recalculated whenever any of these variables is referenced.
+    If the relevant file system does not have the concept of inodes, the value
+    of those variables is -1. If the operating system does not have the ability
+    to find the amount of free space (only true for experimental systems), the
+    space value is -1.
+
+11. It is now permitted to omit both strings after an "if" condition; if the
+    condition is true, the result is the string "true". As before, when the
+    second string is omitted, a false condition yields an empty string. This
+    makes it less cumbersome to write custom ACL and router conditions. For
+    example, instead of
+
+      condition = ${if eq {$acl_m4}{1}{yes}{no}}
+
+    or the shorter form
+
+      condition = ${if eq {$acl_m4}{1}{yes}}
+
+    (because the second string has always defaulted to ""), you can now write
+
+      condition = ${if eq {$acl_m4}{1}}
+
+    Previously this was a syntax error.
 
 
 Version 4.43