2007-03-19 V1.55 Steve Campbell

[exim.git] / doc / doc-txt / ChangeLog

diff --git a/doc/doc-txt/ChangeLog b/doc/doc-txt/ChangeLog
index 9695d2d61d2a8f14d199f79dddf51991c80d473a..b9f9967e63563705fc927044c6d11b60c1ecccf3 100644 (file)
--- a/doc/doc-txt/ChangeLog
+++ b/doc/doc-txt/ChangeLog
@@ -1,4 +1,4 @@
-$Cambridge: exim/doc/doc-txt/ChangeLog,v 1.493 2007/03/13 15:32:47 ph10 Exp $
+$Cambridge: exim/doc/doc-txt/ChangeLog,v 1.498 2007/03/21 15:15:12 ph10 Exp $
 
 Change log file for Exim from version 4.21
 -------------------------------------------
@@ -158,16 +158,40 @@ PH/36 Applied John Jetmore's patch to add -v functionality to exigrep.
 
 PH/37 If a message is not accepted after it has had an id assigned (e.g.
       because it turns out to be too big or there is a timeout) there is no
-      "Completed" line in the log. When such a message was selected by exigrep,
-      it was listed as "not completed". Such messages can be identified by the
-      lack of a "<=" line in the log, and they are now listed as "not
-      accepted".
+      "Completed" line in the log. When some messages of this type were
+      selected by exigrep, they were listed as "not completed". Others were
+      picked up by some special patterns. I have improved the selection
+      criteria to be more general.
 
 PH/38 The host_find_failed option in the manualroute router can now be set
       to "ignore", to completely ignore a host whose IP address cannot be
       found. If all hosts are ignored, the behaviour is controlled by the new
       host_all_ignored option.
 
+PH/39 In a list of hosts for manualroute, if one item (either because of multi-
+      homing or because of multiple MX records with /mx) generated more than
+      one IP address, and the following item turned out to be the local host,
+      all the secondary addresses of the first item were incorrectly removed
+      from the list, along with the local host and any following hosts (which
+      is what is supposed to happen).
+
+PH/40 When Exim receives a message, it writes the login name, uid, and gid of
+      whoever called Exim into the -H file. In the case of the daemon it was
+      behaving confusingly. When first started, it used values for whoever
+      started the daemon, but after a SIGHUP it used the Exim user (because it
+      calls itself on a restart). I have changed the code so that it now always
+      uses the Exim user.
+
+PH/41 (Following a suggestion from Tony Finch) If all the RCPT commands in a
+      message are rejected with the same error (e.g. no authentication or bad
+      sender address), and a DATA command is nevertheless sent (as can happen
+      with PIPELINING or a stupid MUA), the error message that was given to the
+      RCPT commands is included in the rejection of the DATA command. This is
+      intended to be helpful for MUAs that show only the final error to their
+      users.
+
+PH/42 Another patch from the Sieve maintainer.
+
 
 Exim version 4.66
 -----------------