-/* $Cambridge: exim/src/src/daemon.c,v 1.12 2005/06/22 15:44:37 ph10 Exp $ */
+/* $Cambridge: exim/src/src/daemon.c,v 1.23 2007/03/14 12:15:56 ph10 Exp $ */
/*************************************************
* Exim - an Internet mail transport agent *
*************************************************/
-/* Copyright (c) University of Cambridge 1995 - 2005 */
+/* Copyright (c) University of Cambridge 1995 - 2007 */
/* See the file NOTICE for conditions of use and distribution. */
/* Functions concerned with running Exim as a daemon */
goto ERROR_RETURN;
}
-/* Get the data for the local interface address. */
+/* Get the data for the local interface address. Panic for most errors, but
+"connection reset by peer" just means the connection went away. */
if (getsockname(accept_socket, (struct sockaddr *)(&interface_sockaddr),
&ifsize) < 0)
{
- log_write(0, LOG_MAIN|LOG_PANIC, "getsockname() failed: %s",
- strerror(errno));
+ log_write(0, LOG_MAIN | ((errno == ECONNRESET)? 0 : LOG_PANIC),
+ "getsockname() failed: %s", strerror(errno));
smtp_printf("421 Local problem: getsockname() failed; please try again later\r\n");
goto ERROR_RETURN;
}
struct sigaction act;
#endif
+ smtp_accept_count++; /* So that it includes this process */
+
/* May have been modified for the subprocess */
log_write_selector = use_log_write_selector;
extensive comment before the reception loop in exim.c for a fuller
explanation of this logic. */
- for (i = 0; i < listen_socket_count; i++) close(listen_sockets[i]);
+ for (i = 0; i < listen_socket_count; i++) (void)close(listen_sockets[i]);
#ifdef SA_NOCLDWAIT
act.sa_handler = SIG_IGN;
configured value and may therefore already be TRUE. Leave logging
till later so it will have a message id attached. */
- if (smtp_accept_queue > 0 && smtp_accept_count >= smtp_accept_queue)
+ if (smtp_accept_queue > 0 && smtp_accept_count > smtp_accept_queue)
{
local_queue_only = TRUE;
queue_only_reason = 1;
/* Handle the start of the SMTP session, then loop, accepting incoming
messages from the SMTP connection. The end will come at the QUIT command,
when smtp_setup_msg() returns 0. A break in the connection causes the
- process to die (see accept.c). */
+ process to die (see accept.c).
+
+ NOTE: We do *not* call smtp_log_no_mail() if smtp_start_session() fails,
+ because a log line has already been written for all its failure exists
+ (usually "connection refused: <reason>") and writing another one is
+ unnecessary clutter. */
if (!smtp_start_session())
{
if (!ok) /* Connection was dropped */
{
mac_smtp_fflush();
+ smtp_log_no_mail(); /* Log no mail if configured */
_exit(EXIT_SUCCESS);
}
if (message_id[0] == 0) continue; /* No message was accepted */
{
mac_smtp_fflush();
search_tidyup();
+ smtp_log_no_mail(); /* Log no mail if configured */
_exit((rc == 0)? EXIT_SUCCESS : EXIT_FAILURE);
}
if ((dpid = fork()) == 0)
{
- fclose(smtp_in);
- fclose(smtp_out);
+ (void)fclose(smtp_in);
+ (void)fclose(smtp_out);
/* Don't ever molest the parent's SSL connection, but do clean up
the data structures if necessary. */
/* Close the streams associated with the socket which will also close the
socket fds in this process. We can't do anything if fclose() fails, but
logging brings it to someone's attention. However, "connection reset by peer"
-isn't really a problem, so skip that one. If the streams don't exist, something
-went wrong while setting things up. Make sure the socket descriptors are
-closed, in order to drop the connection. */
+isn't really a problem, so skip that one. On Solaris, a dropped connection can
+manifest itself as a broken pipe, so drop that one too. If the streams don't
+exist, something went wrong while setting things up. Make sure the socket
+descriptors are closed, in order to drop the connection. */
if (smtp_out != NULL)
{
- if (fclose(smtp_out) != 0 && errno != ECONNRESET)
+ if (fclose(smtp_out) != 0 && errno != ECONNRESET && errno != EPIPE)
log_write(0, LOG_MAIN|LOG_PANIC, "daemon: fclose(smtp_out) failed: %s",
strerror(errno));
smtp_out = NULL;
}
-else close(accept_socket);
+else (void)close(accept_socket);
if (smtp_in != NULL)
{
- if (fclose(smtp_in) != 0 && errno != ECONNRESET)
+ if (fclose(smtp_in) != 0 && errno != ECONNRESET && errno != EPIPE)
log_write(0, LOG_MAIN|LOG_PANIC, "daemon: fclose(smtp_in) failed: %s",
strerror(errno));
smtp_in = NULL;
}
-else close(dup_accept_socket);
+else (void)close(dup_accept_socket);
/* Release any store used in this process, including the store used for holding
the incoming host address and an expanded active_hostname. */
void
daemon_go(void)
{
+struct passwd *pw;
int *listen_sockets = NULL;
int listen_socket_count = 0;
ip_address_item *addresses = NULL;
{
log_close_all(); /* Just in case anything was logged earlier */
search_tidyup(); /* Just in case any were used in reading the config. */
- close(0); /* Get rid of stdin/stdout/stderr */
- close(1);
- close(2);
+ (void)close(0); /* Get rid of stdin/stdout/stderr */
+ (void)close(1);
+ (void)close(2);
exim_nullstd(); /* Connect stdin/stdout/stderr to /dev/null */
log_stderr = NULL; /* So no attempt to copy paniclog output */
{
DEBUG(D_any) debug_printf("wildcard IPv4 bind() failed after IPv6 "
"listen() success; EADDRINUSE ignored\n");
- close(listen_sockets[sk]);
+ (void)close(listen_sockets[sk]);
goto SKIP_SOCKET;
}
msg = US strerror(errno);
DEBUG(D_any) debug_printf("wildcard IPv4 listen() failed after IPv6 "
"listen() success; EADDRINUSE ignored\n");
- close(listen_sockets[sk]);
+ (void)close(listen_sockets[sk]);
/* Come here if there has been a problem with the socket which we
are going to ignore. We remove the address from the chain, and back up the
if (pid_file_path[0] == 0)
pid_file_path = string_sprintf("%s/exim-daemon.pid", spool_directory);
- f = Ufopen(pid_file_path, "wb");
+ f = modefopen(pid_file_path, "wb", 0644);
if (f != NULL)
{
(void)fprintf(f, "%d\n", (int)getpid());
- (void)fchmod(fileno(f), 0644);
(void)fclose(f);
DEBUG(D_any) debug_printf("pid written to %s\n", pid_file_path);
}
exim_setugid(exim_uid, exim_gid, geteuid()==root_uid, US"running as a daemon");
+/* Update the originator_xxx fields so that received messages as listed as
+coming from Exim, not whoever started the daemon. */
+
+originator_uid = exim_uid;
+originator_gid = exim_gid;
+originator_login = ((pw = getpwuid(exim_uid)) != NULL)?
+ string_copy_malloc(US pw->pw_name) : US"exim";
+
/* Get somewhere to keep the list of queue-runner pids if we are keeping track
of them (and also if we are doing queue runs). */
/* Close any open listening sockets in the child */
- for (sk = 0; sk < listen_socket_count; sk++) close(listen_sockets[sk]);
+ for (sk = 0; sk < listen_socket_count; sk++)
+ (void)close(listen_sockets[sk]);
/* Reset SIGHUP and SIGCHLD in the child in both cases. */
{
uschar opt[8];
uschar *p = opt;
+ uschar *extra[4];
+ int extracount = 1;
signal(SIGALRM, SIG_DFL);
*p++ = '-';
if (deliver_force_thaw) *p++ = 'f';
if (queue_run_local) *p++ = 'l';
*p = 0;
+ extra[0] = opt;
+
+ /* If -R or -S were on the original command line, ensure they get
+ passed on. */
+
+ if (deliver_selectstring != NULL)
+ {
+ extra[extracount++] = deliver_selectstring_regex? US"-Rr" : US"-R";
+ extra[extracount++] = deliver_selectstring;
+ }
+
+ if (deliver_selectstring_sender != NULL)
+ {
+ extra[extracount++] = deliver_selectstring_sender_regex?
+ US"-Sr" : US"-S";
+ extra[extracount++] = deliver_selectstring_sender;
+ }
+
+ /* Overlay this process with a new execution. */
+
+ (void)child_exec_exim(CEE_EXEC_PANIC, FALSE, NULL, TRUE, extracount,
+ extra[0], extra[1], extra[2], extra[3], extra[4]);
- (void)child_exec_exim(CEE_EXEC_PANIC, FALSE, NULL, TRUE, 1, opt);
/* Control never returns here. */
}
int sk;
log_write(0, LOG_MAIN, "pid %d: SIGHUP received: re-exec daemon",
getpid());
- for (sk = 0; sk < listen_socket_count; sk++) close(listen_sockets[sk]);
+ for (sk = 0; sk < listen_socket_count; sk++)
+ (void)close(listen_sockets[sk]);
alarm(0);
signal(SIGHUP, SIG_IGN);
sighup_argv[0] = exim_path;
projects / exim.git / blobdiff